When this happens, the picture is similar to looking through a screen-door. Even though this lattice structure is small, a good camera with an auto focus may try to focus on that structure. After the mirror coating is applied on the clear acrylic at the factory, the clear finish is sprayed over the aluminized coating forming a "LATTICE" structure, which is how the mirror works. This way, if the mirror is scratched on the non-coated side (not the camera side), it will only result in a scratch in the mirror and the two-way affect will still be working.Ģ. For example: If this is to be used with a camera, then place the COATED side on the same side as the camera. If you want to protect the mirror coating form being scratched off, then you will want to protect the COATED side. There is no difference in what side faces in or out when using the mirror, however, the side with the easily removed clear plastic coating is the COATED side of the mirror. This will minimize the chance of it being scratched.ġ. Do not remove the tape and protective clear plastic coating until you are ready to mount or use the mirror. If it is correct you can use a sanding block or belt sander to smooth the edge. When you have finished cutting, check the size before removing the tape. If possible use a fine tooth blade on a table saw or jig saw.)ĥ. NOTE: This is especially true when using a table saw or jigsaw. The general rule is to NOT FORCE THE CUTTING SPEED If you feed too quickly, there is a risk of the teeth catching the acrylic and breaking out small areas. Feed the acrylic through the cutting blade slowly. It helps to use a table stop or guard when cutting straight lines.Ĥ. This will help protect the acrylic surface from getting scratched.ģ. Measure and draw the "cut-line" on the masking tape. By doing this you could save the mirror from accidental damage from scratches.Ģ. Tape the protective paper over the remaining area. Use masking tape to tape over the area where you plan to cut the mirror. Cut the construction paper (anything can be used which will protect the lens from being scratched) to a size smaller than the area you are going to cut but large enough to cover any exposed surface area. We suggest that you protect the coated side with a heavy paper, like construction paper, before doing any cutting. The plastic coating on the coated side will pull off quite easily while the non coated side is noticeably less easily removed. The mirror will be protected with a removable, clear plastic coating on both sides. (Routers also work well.) A veneer saw blade works well when using a table saw.ġ. If you choose to format a mirror or parity space with the Windows Resilient File System (ReFS), Windows will automatically monitor and maintain file integrity to prevent file corruption.Acrylic Mirrors can easily be cut to any size using a "Band Saw", "Table Saw" or any saw with small teeth and a relatively high speed. This solution is ideal for data archival, and not data you use frequently. However, parity spaces are slower than simple and mirror spaces. You’ll have more space and you’ll be protected if a single drive fails. Windows will keep a single copy of your data along with parity information.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |